Finite element model updating based on response surface methodology

12-Oct-2019 11:22

On the other hand, the depth of cut has the most significant effect on the MRR; the cutting speed has less significant effect whereas feed rate has the lowest effect.

Finally, the ranges for best cutting parameters and model equations to predict the cutting force components and MRR are proposed.

Robakidze "Dry Cutting of Hard-To-Machine Materials, with Compensation of the Physical Functions of the Lubricant and Coolant Fluid" Russ.

Mansur "Development of a three-component dynamometer to measure turning force" Int J Adv Manuf Technol 2011, DOI 10.1007/s00170-011-3866-5.

Olusegun "Investigating the cutting forces in heat treated medium carbon steel when turning on a lathe machine" Design and Technology, 2009, Vol.8, No.1, pp.80 - 93.

The short transformation method to predict the FRF of dynamic structures subject to uncertainty// Proc. Journal of Refractory Metals and Hard Materials, 2012, Vol.33, pp. There is a good agreement between the measured and simulated performances. The results were analyzed using an effective procedure of response surface methodology (RSM) to determine optimal values of cutting parameters. Moshksar " Evaluation of machinability in turning of microalloyed and quenched-tempered steels: Tool wear, statistical analysis, chip morphology" Journal of materials processing technology, 2009, Vol.209, pp. This kind of filter is very much compact in nature as compared to the shunt-stub or coupled-line bandstop filters since the spurline structure is confined to a transmission line. Statistical analysis of variance (ANOVA) was performed to determine significance of the cutting parameters. Sharma "Modelling the effects of cutting parameters on residual stresses in hard turning of AISI H11 tool steel. Sutradhar " An experimental study of effect of process parameters in turning of LM6/Si CP metal matrix composite and its prediction using response surface methodology" International Journal of Engineering Science and Technology, 20113, Vol.8, pp.132-141.

The short transformation method to predict the FRF of dynamic structures subject to uncertainty// Proc. Journal of Refractory Metals and Hard Materials, 2012, Vol.33, pp.

There is a good agreement between the measured and simulated performances. The results were analyzed using an effective procedure of response surface methodology (RSM) to determine optimal values of cutting parameters. Moshksar " Evaluation of machinability in turning of microalloyed and quenched-tempered steels: Tool wear, statistical analysis, chip morphology" Journal of materials processing technology, 2009, Vol.209, pp.

This kind of filter is very much compact in nature as compared to the shunt-stub or coupled-line bandstop filters since the spurline structure is confined to a transmission line. Statistical analysis of variance (ANOVA) was performed to determine significance of the cutting parameters.

Sharma "Modelling the effects of cutting parameters on residual stresses in hard turning of AISI H11 tool steel.

Sutradhar " An experimental study of effect of process parameters in turning of LM6/Si CP metal matrix composite and its prediction using response surface methodology" International Journal of Engineering Science and Technology, 20113, Vol.8, pp.132-141.

Rigal "Analysis of surface roughness and cutting force components in hard turning with CBN tool: Prediction model and cutting conditions optimization" Measurement , 2012, Vol.45, pp.344-353.